1. When installing the electronic remote water meter (especially the new pipe section), it should avoid the inclusion of hemp, tape, sand and other debris into the water meter pipe, causing the meter to measure the fault;
2. The diameter of the water meter should be selected according to the diameter of the pipe at the installation site and the flow rate is equal to or less than the flow rate commonly used in the water meter to select the water meter with the appropriate diameter;
3, The installation location should be convenient to disassemble and easy to read the meter data, should avoid exposure to the sun, rain, flooding, pollution and external magnetic interference;
4. The water flow indicator arrow on the case must be consistent with the direction of water flow during installation. The installation method must be installed in the horizontal or vertical direction indicated on the water meter dial with the dial facing up;
5. The electronic remote water meter should be installed horizontally, the dial is facing upwards, and the direction of the arrow of the case is consistent with the direction of the water flow in the pipeline. In order to make the meter accurate and prevent vibration from affecting the life of the water meter, the water meter should be installed away from the water pump and the upstream of the water meter should be installed. The flow straightening device or the straightening straight pipe section, the length of the straightening straight pipe section is greater than 10 times the diameter of the water meter.
