1. Standardize the installation of remote water meters:
Reasonably select the remote water meter model, select the water meter diameter according to the size of the flow used, and determine the flow rate. In order to ensure the most accurate measurement, when installing the water meter, install a straight pipe section of sufficient length to install the flow control valve and filter equipment as required; the position of the water meter should be installed to ensure that the pipe is filled with water and the air bubbles are not concentrated on the table. The meter is installed at the highest point of the pipe, and tilting back and forth or left and right will result in reduced sensitivity and increased error of the remote water meter.
2. Regular troubleshooting of remote water meters:
The remote water meter verification device shall be transmitted according to the quantity value, and shall be verified by the above-mentioned measurement and verification institution within the prescribed time limit, and the error of the error of the instantaneous flow meter and the standard device shall be corrected. If it is not regularly verified, it will not cause the instantaneous flowmeter and standard error due to the verification procedure or irregular maintenance, which will directly affect the accuracy of the water meter verification device, thus affecting the error of the water meter verification. Regularly check the remote water meter and find the error of the water meter as soon as possible in order to correct the error of the remote water meter as much as possible.
